The signal is sent to your daw software allowing the input to be recorded at the same time.Īlthough these interfaces have two inputs, the signal heard back when using the Direct Monitor switch is mono, meaning both inputs are heard in both ears. It takes the input signal on the interface’s inputs and sends it straight to the headphone and line outputs on the device. The above interfaces allow you to directly monitor the signal you’re recording using the Direct Monitor switch.ĭirect monitoring allows a user to listen to the input signal of the interface with near-zero latency. Scarlett Solo 1st, 2nd & 3rd Gen, Scarlett 2i2 1st & 2nd Gen, and iTrack Solo When you press the Direct Monitor button, the interface cycles through each mode.įor direct monitoring on the Scarlett 4i4 3rd gen and larger interfaces that use Focusrite Control, please see this article: Direct Monitoring on the Scarlett 4i4 3rd Gen This is indicated by the green illuminated symbols below the Direct Monitor button. The Scarlett 2i2 3 rd Gen features a Direct Monitor button with three selectable modes off, mono and stereo.
0 Comments
Leave a Reply. |